311129 - Wilson Cellular 800MHz-910MHz Cellular Directional Yagi Cell Phone Antenna

The Wilson Cellular 800-910MHz Cellular Yagi Antenna's main benefit over our other antennas is its ability to focus its signal in one direction. This provides an advantage in weak signal areas or for repeater systems. This antenna is designed for use on stationary objects such as buildings. If this antenna is not aimed correctly it will lose its effectiveness.

The 14.4" boom is the main part of the antenna and includes 5 elements constructed of a single piece of 2mm (14 gauge) aluminum. The Wind Surface Area is less than 16 square inches. The design of the antenna exposes a small profile to wind and ice.

The output coaxial connector is an N-Female type and the feed systems is a "T-Match" which provides low signal loss and wide bandwidth. The antenna's impedance is 50 ohm with a maximum power rating of 10W.

Pipe mount hardware is included. The pipe mount is adjustable to accommodate pipes with and outside diameter up to 2".

Since the Yagi is a single band 800MHz antenna it will only work with 800MHz Cellular and iDEN (Nextel, Southern LINC, Mike) signals. It will not work with T-Mobile, Sprint PCS, or other 1900MHz signals.

Cable

The antenna includes no cable. For a short run of 20' you can use our 20' RG-58 coax extension which has the appropriate connections for the Yagi. Please note that our other RG-58 cables can not be directly connected to the Yagi antenna.

For longer runs, we suggest using one of the lengths of LMR-400 Cable below. This cable is fairly stiff so if you plan on connecting the Yagi directly to your phone with an antenna adapter we suggest you also include an 5' RG-58 extension. The below cables may also be connected together using the N-Female to N-Female barrel connector.

The primary difference between RG-58 and LMR-400 is the dB signal loss. RG-58 loses approximately 12dB/100' while LMR-400 loses about 4dB/100' (which is a big difference).

LMR-400 Extensions Cables:

• 20' LMR-400 Cable
• 30' LMR-400 Cable
• 50' LMR-400 Cable
• 75' LMR-400 Cable
• 100' LMR-400 Cable

A phone adapter cable is required to connect Wilson Cellular antennas to your phone.

Features:

• Compatible with all 800MHz - 910MHz Cellular and iDEN signals
• Directional antenna
• Built-in ground plane
• Pole mounting hardware included (does not include pole)
• For fixed installations
• Antenna is small enough to fit into the 859917 - Portable Amplifier Hard Case with 3 Batteries and All Charging Accessories for Wilson Cellular Amplifiers

Requires:

• Phone Adapter Cable: All Wilson Cellular Antennas require a phone adapter cable in order to connect to your cell phone

Documents:

• Installation Guide (PDF)
• Field Test Modes