|
|
Home > Cell Phone Amplifiers > 801365 - Wilson Cellular Smart Technology 65dB In-Building Wireless 1900MHz PCS Bi-Directional Amplifier
801365 - Wilson Cellular Smart Technology 65dB In-Building Wireless 1900MHz PCS Bi-Directional Amplifier
|
List Price: $749.95
Your Price: Call for Availability
Out of stock
Item Number: 801365
Manufacturer: Wilson Cellular / Wilson Electronics
Manufacturer Part No: 801365
PCS Band Amp, BDA for providing wireless in-building coverage. (Cell Phone Amplifier/Repeater) 1900 MHz PCS Repeater
| Cell phone antennas and amplifiers are frequency specific
(more info). |
|
Wilson Cellular's new series of Smart Technology In-Building Cell Phone Amplifiers offer exceptional performance without causing harmful interference to the cell site.
Wilson Cellular Amplifiers extend cellular services in poor coverage areas by amplifying both transmit and receive signals. The amplifiers reduce problems with signal fades and dropped calls while improving voice quality, service range and access. These multi-mode amplifiers are designed to offer a cost-effective solution for use in buildings. Wilson Cellular amplifiers are network compatible and enhance the cellular phone user's satisfaction without compromising the operation of the cellular system.
This Amplifier-Repeater greatly improves signal strength inside a building when using your cellular phone. It does this without a physical connection to your phone, allowing you to walk freely during a call. It even allows multiple phones to be used simultaneously.
The signal from the cellular tower is received by the outside antenna and then amplifier and repeated to your phone through the inside antenna. When the phone transmits it is received by the inside antenna and then amplified/repeated through the outside antenna to the cellular tower.
Features:
- Works with all generations of CDMA, TDMA, GSM, 1xRTT, GPRS, EDGE, EVDO, HSDPA on the PCS band
- Greater than 65dB computer controlled adjustable AGC dynamic range
- Automatic Gain Adjusting in the event of oscillation and/or overload
- 10dB Gain Steps (35-45-55-65dB)
- Automatic shutdown on overload
- Uplink squelch (optional)
- TIA/EIA-98-E 3.5.1 Receiver Sensitivity better than -110 dBm
- CDMA/rho > 0.912
- Wireless operation - no physical connection to cellular phone
- Maximum 3 Watts Output Power
- High Power Output Allows More Users on the System
- Increases signal strength in buildings for PCS frequencies
- 1850-1910, 1930-1990MHz
- CDMA, TDMA, GSM
- 800MHz Cellular and iDEN/Nextel bands are unaffected/unamplified
- Allows multiple phones to be used simultaneously
- Increases your cellular phone's range
When designing your system, please be sure to allow for 70' of separation between the interior and exterior antennas (20' which must be vertical).
|
Requires:
Optional:
Compatibility:
- Compatible with all 1900MHz PCS service (on-network Sprint PCS, T-Mobile) and technologies (CDMA, TDMA, GSM, 1xRTT, GPRS, EDGE, EVDO, HSDPA)
- Not compatible with 800MHz Cellular
- Not compatible with iDEN (Nextel, Southern LINC, Mike)
- Not compatible with 1700MHz AWS (T-Mobile US 3G)
Learn More:
|
|
|
Example Coverage Estimates using 65dB Amplifier and
|
| Outside Signal
|
Open Area Coverage Distance
from Inside Antenna
|
Very Good (-60dB)
Full Signal
|
Too Strong!
|
Good (-75dB)
Full Signal
|
Too Strong!
|
Marginal (-90dB)
2-3 bars
|
175' or
110' (Driving 2 antennas)
|
Very Poor (-100dB)
0-1 bars
(Not "No Service")
|
50'
|
|
Antennas and cabling pictured are not included.
|
Specifications
|
| Part Number
|
|
801365
|
| Frequency
|
|
1850-1910MHz Uplink
1930-1990MHz Downlink
|
| Gain (up/down)
|
|
65dB / 65dB Max
|
| Linear Output Power
|
|
+30dBm
|
| Max Output Power
|
|
2 Watts (FCC Max)
|
| Max RF (up/down)
|
|
+30dBm / +30dBm
|
| Noise Figure (typical)
|
|
3dB Nominal
|
| Flatness (up/down)
|
|
+/- 4dB
|
| Isolation
|
|
> 90dB
|
| Power Requirements
|
|
120VAC, 225mA Max
|
| Connectors
|
|
N/Female, 50 Ohms
|
| Dimensions
|
|
4.5 * 3.5 * 1.25 (inch)
|
| Weight
|
|
1.5 lbs
|
|
List Price: $149.95
Your Price: $129.95
You Save: $20.00 (13 %)
Protects amplifier from surges resulting from outside antenna being struck by lightning. Includes Ground Wire, Coax jumper and three different types of grounding devices.
|
|
|
Dual-band panel antenna for use as interior antenna in Amplifier/Repeater/BDA Systems.
Compatible with all generations of CDMA, GSM and TDMA including GSM, GPRS, EDGE, UMTS, HSDPA, CDMA, 1xRTT, EVDO, TDMA, AMPS, iDEN, Nextel
|
Your Price: See Wilson 859957 Two Way Splitter
Allows you to drive two interior antennas (up to 4 using multiple splitters) with a single amplifier/repeater
| |
801365 - Wilson Cellular Smart Technology 65dB In-Building Wireless 1900MHz PCS Bi-Directional Amplifier
|
|